Pressing Instructions

DTF Pressing Instructions

We use these instructions for gildan softstyle. 

Suggested Pressing Info

  • Temperature: 315F
  • Time: 15 seconds
  • Pressure: Medium/Heavy

Pressing Instructions

  • Pre-press the fabric for 10 seconds to remove the moisture.
  • Place the DTF Transfer on the fabric then use a Teflon sheet on top and press for 15 seconds.
  • Remove the fabric from the heat press and wait for the DTF Transfer to cool down and peel. COOL PEEL
  • Place the fabric back onto the heat-press, use a Teflon sheet on top, and press for 7 -10 seconds.
  • Done!

These instructions may vary depending on the material you are pressing. Always do a test first. Adjust as needed.

100% Polyesters 300F for 10 seconds.

100% Thick Cotton 315 for 20 seconds.

 

Sublimation Pressing Instructions

These times & temperatures are a good place to start, but you may have to adjust due to different heat presses and product quality. Producing quality end products is a matter of suitable substrates, a calibrated heat press, smart color management following manufacturer guidelines, testing and practice!


Ceramic Mugs

  • 150-210 seconds
  • 350-400° F
  • 40 psi (medium)
  • Time varies with press. Press into silicon pad. Mugs should be cooled down after transfer paper is removed in either a bucket of warm water or using a cooling plate.

Stainless Steel Tumblers 

  • 365° F
  • 40 psi (medium)
  • Time varies with press. If you are doing a full wrap, press for 45 sec. then rotate your tumbler 180 degrees and press a second time for 45 sec.
  • If using a toaster oven, it’s suggested to bake at 365 for 6 min turning after 3 min.

Polyester Fabric

  • 35-45 seconds
  • 400 - 410° F
  • 204 - 210 C
  • 40 psi (medium)
  • Pre-press shirt for 3-5 seconds to eliminate moisture. 

Polyester with Foam Backing (Koozie / Mousepad)

  • 45 seconds
  • 400° F
  • 204 C
  • 40 psi (medium)

Metal

  • 45 seconds
  • 375°-400° F
  • 190 - 204 C
  • 40 psi (medium)
  • Time varies with metal manufacturer. Place absorbent sheet on bottom of heat press. 

Glass or Ceramic Tiles

  • 300 - 720 seconds
  • 400° F
  • 204 C
  • 40 psi (medium)
  • Time varies depending on tile type and size. 

Glass

  • 180 - 240 seconds
  • 360 - 400° F
  • 182 - 204 C
  • 40 psi (medium)
  • Be careful not to put too much pressure on the glass. This can shatter it. Wear protective gear. 

Polyester Linen

  • 55 - 65 seconds
  • 385 - 425° F
  • 196 - 218 C
  • 40 psi (medium)
  • Peel transfer while hot. Press with substrate facing up and transfer paper on top.